How to Install Bull Nose Rubber Stair Treads

How to Install Bull Nose Rubber Stair Treads

Rubber stair treads can prevent many accidents and will greatly improve safety on the stairs. Installing bull nose rubber stair treads could help to prevent accidents and will preserve each stair treads finish from wear. Install stair treads on any smooth dry interior step provided the shape of the step are conforms to the underneath of the stair tread.

Preparation for installation bull nose rubber stair treads:

How to Install Bull Nose Rubber Stair Treads

  • Surfaces of the steps must be clean, dry and free from oil, grease, rust and adhesives before installing stair tread. Wooden steps should be thoroughly nailed down.
  • Any other irregularities on the step should be repaired by filling and smoothing with an appropriate underlayment.

Fitting and cutting stair treads:

Stair treads are usually supplied oversize with untrimmed ends and that are processed to allow extra material to compensate for variations in step dimensions. Rubber stair treads should be individually timed to fit each step from side to side. The stair treads can be marked with a steel straight edge and a knife. Precaution is required to avoid injury while using any sharp tool to cut the material.

The one of the most important factor in stair tread installation should be no air space exists underneath the nosing part of the stair treads. The bull nose rubber stair tread should not flex or move as traffic walks across the steps. For perfect step, epoxy nose caulk should be used under the stair tread to fill any air space.

It is important to use the correct adhesive. For vinyl stair treads contact adhesive must be used. For bull nose rubber stair treads, install with suitable rubber flooring adhesive, depending on service conditions.

Why installing a stair nosing on the edge?

The durability of the stairs has always been a concern for architects and constructors. You will notice superb step edgings that most properly inspired stair nosing designers. The stair nosing that is installed on the step edge of ceramic tile or wood covered stairs.

Rubber stair treads nosing which is installed directly on the concrete stair step edge. These stairs nosing may only be fitted during the tile, marble and stone installation process.

The grooves on the bull nose rubber stair nosing will add a feature to the safe use of the stairs. The non-slip stair nosing is highly recommended to protect tiles on stairs from chipping.

Repairing your rubber stairs is a safety:

If you have a set of concrete stairs that are starting to chip these should be repaired with a bit of effort. If you have a set of stairs are getting a little unsafe then it is time to evaluate by doing it itself repair can fix the problem. Not all the stairs are built the same so the first thing to do is to assess the problem.

After the installation process is over leave the surface treatment to stair treads for about the week to become tightly bonded to the steps.